Pinetown-20120315-00366TILT IN SPACE

Proper fit of wheelchairs

Information I found helpful

Proper fit of a wheelchair
From ATWiki –
How do you know when a wheelchair fits you? What happens if it doesn’t fit? Does one size fit all? Not usually. Especially for full-time users.
Wheelchairs come in all shapes and sizes. People who have issues with immobility or decreased sensation frequently cannot maintain proper positioning or are unaware that they have swayed from an upright, symmetrical posture. A symmetrical posture can lead to problems with function, skin integrity, breathing, swallowing and digestion. For these people, it is imperative that the seating system be measured appropriately for them.
Important anatomical measurements to consider are hip width, femur or upper leg length, lower leg length, trunk height, buttock to elbow (when bent) height, chest width, chest depth, and forearm length, among others. These measurements can then be translated into equipment dimensions by a therapist or equipment supplier when the wheelchair and seating components are ordered.
What happens if a seating system doesn’t fit right?
Seat width
Seat depth
Seat height
Leg rest length/footplate height
Back height
Back width
Armrest height
Armrest length

Seat widthTypically, the seat width is usually close to the hip width-or widest part of the body (taking into consideration recent weight gain/loss, seating components, and large postural deformities).
If the seat width is too wide, it can:

  1. Create a pelvic obliquity (one side of the pelvic higher than the other) and scoliosis (lateral curve of the spine
  2. Impair appropriate positioning of secondary supports of the seating system (trunk supports, thigh supports…)
  3. Impair access to wheels/joystick/armrests
  4. Impair accessibility (especially in manual wheelchairs as the overall chair width increases with increasing seat width).

If the seat width is too narrow, it can:

  1. Create rotational deformities
  2. Cause discomfort
  3. Increase pressure on the lateral thighs (trochanters) or lower legs.

Seat depth
The seat depth should be slightly shorted than the upper leg/femur length (taking into consideration functional issues such as foot propulsion/leg management; pressure distribution; knee range of motion, leg length discrepancies/leg alignment; hanger angle of the leg rest).
If the seat depth is too long, it can:

  1. Create posterior pelvic tilt, kyphosis, sliding out of seat, shear (overall contributes to poor posture, risk of skin breakdown and need for frequent repositioning)
  2. Increases overall frame length (impairs maneuverability/increases turning radius)
  3. Impede transfers (can’t get all the way back on the seat).

If the seat depth is too short, it can:

  1. Cause hip external rotation and abduction
  2. Increase pressure on IT’s (ischial tuberosities or “sitting bones” )
  3. Impede transfers (less space to clear the tire for lateral transfers when using a manual wheelchair).

Seat heightSeat height depends on many factors. Generally, a seat height that provides 2” of ground clearance under the footrests is the minimum seat to floor height. Access to the hand rims for propulsion, transfer heights, and functional reach are some other factors to consider when determining seat height. Someone who propels with one or both feet requires a lower seat to floor height than anyone else to achieve adequate contact with the ground.
If the seat height is too high, it can:

  1. Cause foot propellers to slide out of chair
  2. Impair access to wheels (leading to inefficient propulsion)
  3. Impair accessibility (van, tables-raises head/knee height).

If the seat height is too low, it can:

  1. Impair transfers (sit-stand, sliding board/depression to higher surfaces)
  2. Decreased ground clearance
  3. Impair accessibility (lower overall height impairs ability to reach objects with arms).

Leg rest length/footplate height
The length of the leg rest should be set so that the thigh rests parallel to the cushion surface with the foot comfortably placed on the footrest. Ankle plantar flexion contractures and other foot deformities need to be taken into consideration when the leg rest length is determined to prevent the thigh from rising off the cushion surface.
If the leg rest length is set too long, it can:

  1. Cause increased pressure on posterior thigh, leg edema, and hip internal rotation on upholstery seating
  2. Decrease ground clearance
  3. Cause sliding down in seat to meet footplates.

If the leg rest length is set too short, it can:

  1. Increase pressure on ischial tuberosities (sitting bones), cause hip abduction pressure against leg rest hangers.

Back height
The back height is measured from person’s buttocks to top of shoulder. The placement of a wheelchair back is dependent on function and postural deformities: UE propulsion, balance, kyphosis.
If the back height is too high, it can:

  1. Impair propulsion, scapular mobility
  2. Lead to kyphotic posture
  3. Impair sitting balance.

If the back height is too low, it can:

  1. Lead to kyphotic posture
  2. Impair sitting balance
  3. Cause inappropriate placement of anterior support devices for the shoulder/chest.

Back widthBack width is typically determined by the seat width, but can be different from the seat width with certain wheelchair back choices. Chest width and the need for external trunk supports are important considerations.
If the back width is too wide, it:

  1. May inhibit the ability to place secondary supports (trunk supports) in appropriate place
  2. May impede arm function.

If the back width is too narrow, it can cause:

  1. Edges/back posts dig into back
  2. Insufficient room for trunk supports
  3. Rotational deformities.

Armrest heightArmrest height needs to meet height of the flexed elbow when seated. Consider addition of lap trays, custom arm supports.
If the armrest is set too high, it can:

  1. Increase pressure on glenohumeral joint and cause pain
  2. Cause difficulty maneuvering joystick.

If the armrest is set too low, it can:

  1. Create kyphosis or scoliosis
  2. Increase pressure on ischial tuberosities
  3. Cause or worsen shoulder subluxation.

Armrest length
Arm length is measured from elbow to wrist or end of fingertips. Armrest length varies depending on amount of support required.
If armrest length is too long, it can:

  1. Limit desk/table clearance.

If the armrest length is too short, it:

  1. May impair sit-stand transfers
  2. May not support lap tray/items on it.

Does it matter if a seating system fits right? Absolutely!
Chris Maurer, MPT, ATP
Shepherd Center, Atlanta, GA
Center for Assistive Technology and Environmental Access, Georgia Institute of Technology
Email Address:

Retrieved from “


Let me know you were here... leave a comment

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s


My ramblings of a mad world we live in. And some other helpfull topics will be added from time to time.

Gingers, Poetry, Nonsense, Red Hair, Hope, Sausages

Unbagging the Cats

Myositis is a neuro muscular disorder

Get it. Write.

Your purpose in life is to find the purpose of life.

Lynette Noni

Embrace The Wonder


Poems and Ponderings by Jake

Desire Says ...


AllThingsBoys Blog

Humor in the Humorless


You - philosophical, thoughtful, witty. Me - still thinks fart jokes are funny. We should DEFINITELY get together!


I write, I read . . . and I eat chocolate - probably more than I should . . . the chocolate that is


Pondering lifes blessings one memory at a time

Menimèse Creare

Days of Yore & More


Crazy is relative. Just ask my relatives. And music!

renxkyoko's space

Just another site

Pushing on a Rope

Working my way through midlife, one laugh at a time

The Chatter Blog

Living: All Day Every Day: Then Chattering About It


A frustrated writer, who is her own worst enemy

Gobetween Flames site about my life and interests.

%d bloggers like this: